IMP400
5/15
Copyright © 2014 Ingenico
900021684 R11 000 01/0615
All rights reserved
3.
Recommendations
3.1.
Security
IMP400 is specially designed for iSMP2 Companion terminals charging.
Do not short-circuit the metallic contacts.
Do not attempt to open the product or the PSU.
Do not attempt to replace the PSU by any other type even the characteristics
are similar.
In case of abnormal behaviour disconnect the main power cord from the wall
plug.
Electrical power outlet and power cord:
Power outlet must be installed near the equipment and easily accessible;
Main plug of power cord must meet standards and regulations of the country it
is used in;
The protection of the installation must be set to 20 A in US and Canada, 13 A in
the UK and 16 A in other countries.
Warning
In such case all the certifications below and warranty for ISMP2 COMPANION
and IMP400 would be voided
3.2.
Approvals and markings
Mandatory conformity marking for products sold within the
European Economic Area (EEA). It states that the product is
assessed before being placed on the market and meets EU
safety, health and environmental protection requirements
Indicates that the product has been certified to applicable
standards including standards written or administered by the
American National Standards Institute (ANSI), Underwriters
Laboratories (UL), CSA Group (CSA), NSF International (NSF),
and other North American and global organizations
Indicates that the product meet both American and Canadian
standards for safety requirements
Indicates that the product has been evaluated, tested and certified
for electrical safety by an independent accredited third-party
against German and European standards
Mandatory mark for Japan according to the Electrical Appliance
and Material Safety Law (DENAN)
Proof a regulated energy-using product imported into Canada has
been successfully tested and certified by an impartial and
independent Testing Laboratory accredited by the Standards
Council of Canada (SCC)
