Copyright© 2022 Ingenico
All rights reserved
18
Desk/2600 User guide
900049361 R11 000 02 07/22
4.6.3
Charging the battery
Desk/2600 has been designed to be used with PSU and battery
connected. The terminal autonomy (without PSU) is small and authorizes
few transactions when PSU is disconnected. Battery is mandatory for
printing and connecting 4G/2G network. If the battery level is too low,
these functions may be not working.
On initial start-up
, charge the battery for xx hours under the
environmental conditions stated above.
The battery can only be charged by using the power supply included
with the product to ensure best performance and safety. Connect the
terminal power supply directly to the terminal USB-C connector located
behind the battery door or to the magic box USB-C connector marked
“PSU” (See chapter “Installation”).
4.6.4
Changing the battery
It is imperative to use the battery authorized by Ingenico.
There is danger of explosion if battery used is not
approved by Ingenico.
Disconnect the power supply unit
Turn product off by pressing simultaneously (dot key) and
(yellow key) for one second.
Remove the battery door (See chapter “Installation”).
Lift the battery and remove it from its compartment.
Carefully disconnect battery by pulling on connector. Avoid
pulling wires to do not damage the battery.
Connect and install the new battery by following the instructions
in chapter “Installation”.
In order to preserve the environment, dispose used battery in
compliance with current country recycling legislation.
