7
Ignition
MOST IMPORTANLY, FOLLOW THESE STEPS!!
· Make sure that the thermostat knob is in position “0”
• Turn the thermostat knob clockwise. First of all, the white pilot will turn on, indicating that
the machine has current. Turn the thermostat knob clockwise to the desired temperature,
graduated in various positions from 50º to 300º C, the red pilot will turn on, indicating that the
resistance is in operation.
To turn off the grill:
· Turn the thermostat knob anticlockwise until the “0” position and the resistance will be
disconnected and the machine won’t have current.
After installing the appliance, and before use, it is necessary to perform a cleaning of the plate.
Then the appliance should be working for about 20 or 30 minutes so all the fat burning and
odors that might have never been used disappear.
MAINTENANCE
Given the simplicity of these appliances, there are few aspects to which attention should be
paid from the preventive point of view.
Cleaning
· Daily clean the surfaces of stainless steel, with soap and warm water. Never use
sandy
detergents or abrasive substances.
· Clean both the plate and the collection tray of fats with a degreasing agent, in order to prevent
the accumulation of fat and this avoid that you can catch fire.
· It is not convenient to use
water hoses
for cleaning, since it can affect the functional
elements.
Replace of functional components
Replacement of any part which composes it may be needed throughout the life of the
equipment. The most important pieces for the proper working of the machines are the follows:
∙
Thermostat
∙
Resistances
∙
White
pilot
∙
Red
pilot
The replacement of any functional component that could affect safety must be performed by an
authorized servicer.
As
a
general
rule,
the
whenever
you
replace
any
parts,
disconnect
the
appliance
from
the
mains.
Problems and solutions
We indicate faults which can present and their possible solutions:
· Put into operation the thermostat, pilot does not light up:
- Check that the mains switch is connected.
- Check for voltage in the mains.
- The pilot lamp is burned out.
Solution:
replace the pilot.
· The thermostat does not cut current when the plate reaches the selected temperature:
- Check that the thermostat bulb is in your accommodation.
- The thermostat bulb is broken.
Solution:
replace the thermostat.
