2
ASSEMBLY INSTRUCTIONS – ELECTRIC HEATER
This heater must be permanently installed and hard wired by a licensed electrician. Assembly
procedure must be performed with no electrical power to unit.
NOTE: To prevent breakage, unit is shipped without the element installed.
1. Check UL/CE label on Heater for proper voltage
2. Remove two end reflectors.
3. Open element clips at each end of the Heater and carefully install the quartz tube.
Remove one nut from end of element. Slip on wire over element screw. Replace nut.
NOTE: Hold element ceramic firmly while tightening nut to prevent damage to element.
Nut should be tightened snug, a loose connection can cause element to short or fail.
Connect other side of element in like manner. Close element clips over tube.
4. Replace end reflectors.
5. If necessary, clean tube and reflector with alcohol or equivalent.
6. Snap on protective grill provided.
WIRING INSTRUCTIONS
1. Remove cover plate from junction box.
2 Attach conduit.
3. Use only copper or aluminum wire
suitable for 90°C.
4. Replace cover plate.
5. Observe local electrical code
regulations.
OUTDOOR INSTALLATION
1. Heater must be mounted with reflector
angled down.
2. All electrical connections must be in
compliance with the National Electric
Code and local codes for outdoor
wiring.
3. Use only wiring components UL/CE
listed for outdoor use with IP X 4
minimum rating
WARNING
Unit may be a source of possible shock.
Unit may be a source of possible ignition, maintain required clearances to all combustibles.
Never block the front panel of the Heater.
Do NOT operate within 25 feet of flammable/explosive material.
NEVER attempt to service Heater without disconnecting it’s power source.
This appliance is not intended for use by young children or infirm persons unless they
have been adequately supervised by a responsible person to ensure that they can use the
appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
Do not use if the heating element is damaged.
The heater must be installed at least 7’ (2.1 mm) above the floor.
A means for disconnection of the appliance must be incorporated in accordance with the
local wiring codes.
Alfresco-Heating.com 888-Warm-Glo
