Press the blue button to switch the device ON and OFF.
Press the yellow button. The reversed triangle LED will light up for
2s:
Data recording will begin after the reversed triangle LED has
extinguished or, if the device‘s default settings have been changed
via software configuration, after the specified initial delay period.
When the initial delay period (if any) has passed the device status
changes to logging mode.
It is not possible to start logging if there are currently data stored
in the device‘s data storage. If this is the case the reversed tri-
angle LED will be blinking 10 times:
You then have to erase the stored data (see 4.5) prior to be able
to start logging.
It is also not possible to start logging if the device‘s memory is
not completely erased because an erasing process has not suc-
cessfully been completed . If this is the case the upright triangle
LED will be blinking 10 times:
You then have to erase again the stored data (see 4.5) and make
sure that the process is completed successfully prior to be able
to start logging.
Press the yellow button for at least 2s. The square LED will light
up when logging has been terminated:
You can also just switch off the device with the power button. This
will not affect the collected data in any way.
(It is not possible to stop logging when the device is waiting for
an initial delay to pass. If you want to cancel logging within this
period you have to switch off and on the device with the power
button.)
4.0 Operation
4.1 Power
4.2 Start data logging
4.3 Stop data logging
Page - 5 -
10x
10x
