INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - [email protected] – 07 19 AA 36 205 09
22
Alarm/Fault
Sound disable
(Press the mute key
3s to disable and
enable the buzzer
sound)
Note : 1 segment = 25%
Bat mode: battery
capacity
Line mode:
1. Battery charging:
flashning
2. Battery full
charged: lighting
Load capacity
Input indications :
Initial
2th
3th
Line
mode
Batt.
Mode
3.3 Audible alarms
Alarm
Condition
Off
Normal
Beep 1 time In Every 30 Seconds
Utility Failure – The UPS is providing battery power to outlets.
Beep 1 time In Every 2 Seconds
Utility Failure – The UPS is providing battery power.
The rapid beeps indicate the battery will run out of power shortly.
Beep 1 time In Every 0.5 Second Overload - Occurs when connected equipment exceeds the rating of the unit.
Turn the UPS off and unplug at least one piece of equipment from the UPS.
4. TROUBLESHOOTING
Refer to the table below when the UPS is not working properly.
Problem
Possible Causes
Remedy
Abnormal
Mains normal
but not Works
in AC mode
1. AC Input missing
1. Check AC input connection.
2. Input Breaker is tripped 2. Unplug the power cord of the UPS, then press the
circuit breaker knob.
