1.
When wall mounting, securely fasten the L
-
shaped wall
brackets to the mounting surface using both of the fixing
holes in the short part of the bracket (see Fig. D for
mounting hole centres). Please refer to Table 1 for
recommended positioning of the heater. Please note. wall
fixings are not supplied. They should be selected to
substantially support the weight of the installation. If in
doubt contact a professional for advice! When hanging
from a ceiling two equal length and gauge chains are
required and should be selected with fixings that are
adequate to hold the weight of the heater. Again, if in
doubt contact a professional for advice!
2.
The heater should be mounted with the terminal box at the
bottom of the heater when being wall mounted.
3.
When wall mounting, fix in the required angular position by
tightening the fixing bolts on the brackets at the rear of the
heater as shown in Fig. C. The heater should face directly
down when hanging.
4.
Secure the supply cable so it is not resting on the body or
obstructing the air
-
vents.
Always isolate the heater from the mains supply when
adjusting the position.
DRILLING HOLE TEMPLATE DIMENSIONS FOR WALL MOUNTED BRACKETS
Fig. B
•
Always allow the heater to cool before attempting to
reposition/move. Never attempt to move the heater while it
is switched on!
•
Observe the minimum safe distance between the heater
body and inflammable surfaces and objects when mounting.
•
Please refer to Table 1 for the recommended positioning of
the heater with regards to minimum distances. Do not install
the heater in a corner!
•
Keep out of the reach of children.
Fig. C
TERMINAL
BOX
Fig. D
7
S
E
E
T
A
B
L
E
1
F
O
R
M
IN
IM
U
M
D
IM
E
N
S
IO
N
S
