InfoPrint 6500-v05, User Manual

Page: 246 / 340

Table 11. Fault Messages (continued)
Fault Message
Operator
Correctable?
Explanation Solution
143 SHUTL DRIVER FAILED*
SEE USER’S MANUAL
No Shuttle driver failed. The
shuttle driver circuit on the
controller board is drawing
too much current. Contact your InfoPrint
Solutions Company service
representative.
144 SHUTTLE FAN FAILURE*
SEE USER’S MANUAL
No The shuttle fan fails to blow
correctly. Contact your InfoPrint
Solutions Company service
representative.
146 RIBBON INK OUT
INSTALL NEW INFOPRINT RIBBON Yes RibbonMinder software has
determined that the ribbon is
out of ink. Change the ribbon or reset the
RibbonMinder to a lighter
setting. See “Ribbon End Point”
on page 53.
147 H/B CONTROL MODE
SEE USER’S MANUAL
No One or more hammer coils is
overheating. Contact your InfoPrint
Solutions Company service
representative.
148 DRIVER CIRCUIT BAD
SEE USER’S MANUAL
No Driver circuit is faulty. The
hammer coil count test
failed. Contact your InfoPrint
Solutions Company service
representative.
149 HMR BANK NOT
INSTALLED
SEE USER’S MANUAL
No Hammer bank not installed. Contact your InfoPrint
Solutions Company service
representative.
150 ERROR: EC STOPPED AT
STATE
XXXX
No XXXX is a number from
0000 to 0010. The Entine
Controller has stopped and
is in the state identified by
the number displayed.
Contact your InfoPrint
Solutions Company service
representative.
159 HAMMERBANK HOT No The hammerbank is
overheating. Contact your InfoPrint
Solutions Company service
representative.
160 ERROR: DC PROGRAM
NOT VALID No The printer cannot find the
data controller program or
the validation checksum is
corrupt. Contact your InfoPrint
Solutions Company service
representative.
161 ERROR: DRAM AT
ADDRESS
XXXXXXXX
No The printer found a defective
memory location. Contact your InfoPrint
Solutions Company service
representative.
162 ERROR: EC PROGRAM
NOT VALID Yes The printer cannot find the
engine controller program or
the validation checksum is
corrupt. Download the program again.
If the fault message appears
again, contact your InfoPrint
Solutions Company service
representative.
163 ERROR: FLASH DID NOT
PROGRAM Yes The printer encountered an
error trying to program flash
memory. Download the program again.
If the fault message appears
again, contact your InfoPrint
Solutions Company service
representative.
164 ERROR: SDRAM JEDEC
MISSING No The printer could not find
JEDEC table for SDRAM
using default values. Contact your InfoPrint
Solutions Company service
representative.
230
InfoPrint 6500-V User’s Manual