3
F
IGURE
2
Projector
Usage Guidelines
•
Do not look directly into the projection lens when the projector
is turned on. The bright light may harm your eyes.
NOTE
: If you turn the projector
off then back on again, it takes
about 30 seconds for the lamp to
light.
•
Do not block the grills on the projector. Do not place the projec-
tor on cloth table coverings, as they may get sucked up to the
vents. Restricting the air flow can cause it to overheat and turn
off.
•
Handle the projector as you would any product with glass
components. Be especially careful not to drop it.
•
Avoid leaving the projector in direct sunlight or extreme cold
for extended periods of time. If this happens, allow it to reach
room temperature before use.
•
This projector is not intended for use in a mainframe computer
room as defined in the Standard for the Protection of Electronic
Computer/Data Processing Equipment, ANSI/NFPA 75.
•
Transport the projector in a vendor-approved hard or soft case.
Part numbers for these cases are listed on page 52. Call your
InFocus dealer to order.
connector panel
elevator button
speaker
power
cord
connector
keypad
remote control
receiver
focus ring
zoom ring
Summary of Contents for LP755
