InFocus INF7020, User Manual

Page: 12 / 15

Page 10
LED Error Codes
1 2 3 4 5 6 7 8 9 10
When an error occurs, the volume strip (LEDs #1 - 7) turns solid except for the LED which indicates which error condition is occurring
(that LED will be flashing). LEDs #8-10 are not used for error conditions.
LED 1 LED 2 LED 3 LED 4 LEDs 5-7 Error Type Troubleshooting Tip
Blinking Solid Solid Solid Solid An SPDIF compressed format
detected Configure the DVD player (or audio source
device) audio output format setting to PCM
or PCM stream. Otherwise, use the Analog
RCA inputs from the audio source to the
sound bar without configuration of the audio
source device.
Solid Blinking Solid Solid Solid The SPDIF rate is unsupported Configure the audio sample rate of the audio
source device to be either 44.1 KHz or prefer -
ably 48KHz.
Solid Solid Blinking Solid Solid An over-current error has
been detected Reduce the volume setting of the sound bar
and subwoofer temporarily, and turn the unit
off for a short period and back on to reset
the circuitry. If this indication continues to
occur, then reduce the volume level for the
particular source content being played.
Solid Solid Solid Blinking Solid Thermal Shutdown has oc -
curred.
Turn off the sound bar and verify the ven -
tilation slots in the sound bar are clear, the
sound bar has proper ventilation and is not
being operated in an environment
that is too hot. If these conditions exist,
reduce the volume level for the particular
source content being
played.
For additional troubleshooting support, please contact:
InFocus Corporation
Technical Support
6am-5pm PST
877-388-8385
www.infocus.com/support