24
Using the remote control
The remote uses two (2) provided AA batteries. You can install the batteries
by removing the cover from the remote’s back, aligning the + and - ends of
the batteries, sliding them into place, and then replacing the cover.
Caution
:
•
When replacing the batteries, be aware that using batteries other than
the type provided with the projector may risk severe damage to the
remote. When disposing of the batteries, be sure to do so in an environ-
mentally proper manner.
•
If the remote control gets wet, wipe it dry immediately.
•
Avoid excessive heat and humidity.
•
Ensure the batteries’ polarity (+/-) is aligned correctly.
•
Do not mix new and old batteries together, or different types of batter-
ies together.
•
Replace the batteries as soon as they run out.
•
Remove batteries from the remote control when storing or not in use
for a prolonged period.
To operate, point the remote at the front of the projector (not at the
computer). The range of optimum operation is about 30’ (9m).
Press the remote’s
Power
button to turn the projector on and off (see page 16
for shutdown information).
Press the remote’s
Menu
button to open the projector’s menu system. Use
the arrow buttons to navigate, and the
Select
button to select features and
adjust values in the menus. See page 28 for more information on the menus.
The remote also has:
•
Source
button to switch between sources.
•
Volume
buttons to adjust the sound.
•
Custom
button that can be assigned to a special function, like Blank
Screen or Freeze (see page 31).
•
Help
button to access the projector’s help feature (see page 34).
•
Blank
button to blank the screen.
•
Presets
button to select stored settings (see page 29).
•
Mute
button to silence the audio.
•
Auto Image
button to resynchronize the projector to the source.
•
Resize
button to switch among aspect ratios (see page 29).
Wired Remote Option
If the wireless range of the standard remote is not sufficient, an optional
Commander-2 remote can be wired directly into the projector’s Wired
Remote connector.
Troubleshooting the remote
•
Make sure the batteries are installed in the proper orientation and are
not dead.
•
Make sure you’re pointing the remote at the projector or the screen, not
the computer, and are within the remote range of 30’ (9m). For best
results, point the remote at the projector.
Navigation
buttons
