Auto Home Base
1.
1.
1.
2.
2.
2.
3.
Preparations
Find a proper place(we recommend a hard surface floor)to put the Self-Charging
Home Base in the room. Leave about 60cm (2ft) clearance around the Home Base.
Connect the battery charger to the power input socket on the back of home base first.
Then, place home base against the wall. Don’t leave loose wire around the wall.
Finally, plug battery charger to AC power outlet on the wall.
Make sure the LCD display on the Home Base is on. This means that the Home Base
has been powered on, and it is ready to charge the QQ6.
Wire slot
charger socket
Please settle down
the cable of charger
into the back side
slot of base.
Testing the Home Base
Battery Charging Methods
Auto Charging:
Auto Charging:
Clean Mate QQ6 can automatically return to the Charging base to
charge itself when battery runs low .User can also press
HOME
on remote control to let it return to the base at any time.
“
”
Users can always plug the battery charger to side Charging
socket on Clean Mate QQ6 to charge it manually. See below.
Put the QQ6 on the floor close to the Home Base and turn it on, Now press the
"Home" key on remote control. The QQ6 should return to the Home Base
automatically for self-charging.
Make necessary adjustment to the Home Base if the QQ6 can not dock on the Home
Base properly.
back and bottom of the unit.
Cleaning Dust Bin and Air Filter
Washing Dust Bin and Air Filter
Please follow Fig.1 to Fig.6 to clean it.
(In Fig.2, you can see Open-button at side of dust bin)
Please follow Fig.11 to separate Dust Bin and suction motor unit.
Follow Fig.12
, to wash it.
Follow Fig.14, 15 to install it.
、13
Cleaning and Maintenance
Cleaning and Maintenance
3.
on the
QQ6
Slot
Fig 14
Fig 15
Fig 11
Fig 12
Fig 13
15
10
Charger plug-in socket
10
Remove the insulation sheet
Pull
ut
o
Fig1
Fig2
Fig3
Fig4
Fig9
Fig8
Fig7
Fig6
Fig5
Fig10
Power Switch
ON
OFF
Make sure the
power switch is
in position of “ ”
