16
______________________________________________________
Operation and Care
Auto-Fill™ & Auto-Drain™ with D.A.S Models:
Auto-fill can be operated by either Auto-fill /Jet Knob or Digital Automated System (DAS)
1.1 Use faucet knob to adjust optimal water temperature at “H” or “C” directory.
1.2 Pull out and tilt down faucet knob to shut off water any time during the automatic or manual.
Faucet Knob must be used to shut off water supply to basin when spa
chair is left unattended and overnight
Auto-Fill™ / Jet Switch:
(
Dual-functional momentary switch located on the right side of the front panel
)
1.
To turn water on:
Turn knob clockwise for 1 second and release. Water will fill up to reach the
sensor level and activate the whirlpool jet
2.
To turn water off:
Turn knob clockwise for 1 second and release to turn off water. The switch can
be activated to turn on or turn off water any time during the Auto-Fill™ cycle, EXCEPT when water
is at sensor level.
NOTE:
Activate this Auto-Fill/Jet Knob:
1.
When water is running, system will resume with turn off water.
2.
When Whirlpool Jet is running, system will resume with turn off Jet
3.
When water is full and Jet is off, system will resume with fill up water for 3sec and Jet turns on.
4.
When water level is low, system will resume with fill up water prior activating whirlpool jet
5.
Drain Switch:
(Dual Action Electro-mechanical Switch located on the left side of the front panel)
When activating the switch, it will raise the drain-stopper and power up the drain pump (if exist) at the
same time. 2 Drain Sensors are located at bottom of basin need to be cleaned frequently as needed
to ensure operation properly
1.
To drain water:
Turn the drain knob clockwise. Drain pump is activated and will be turned off
automatically when water is empty.
3.
To turn off the drain pump:
Turn the drain knob counterclockwise any time to stop drain pump
CAUTION: Reset the Drain knob to vertical position to close the drain stopper prior fill up water
