38 | ISE-XH12ZWDN650 FD
ISE-XH12ZWDN650 FD | 39
ENG
6.CAMERA SETUPS AND CABLE CONNECTIONS
Before installing or connecting the Dome Camera, please refer to this section and complete preparations for Dome
Camera setups and various switch settings.
The following installation procedure is for the outdoor Dome Camera equipped with the sunshield. Please follow the
steps below to install dome cover and detach the Outdoor Mount Kit from the camera body for switch setups.
6.1
PREPARATIONS FOR DOME CAMERA SETUPS
STEP 1
Unpack the Dome Camera’s package and
take out the Dome Camera unit.
STEP 2
Turn the Dome Camera upside down and
place it on the cushion. Then rotate the
Outdoor Mount Kit counterclockwise and
detach it from the camera body.
STEP 3
Remove the protective cover and PE sheet
from the camera.
STEP 4
Smear some lubricant on the surface of
the dome cover’s waterproof rubber ring.
Then attach the dome cover to the camera
body by first aligning the center point on
the dome cover with one of the four holes
on the dome camera housing as shown in
the figure.
STEP 5
Gently press down the dome cover with
two hands on the side of it. Make sure the
two Slotted Screws and the screw hole on
the dome cover align with the three holes
on the camera housing.
DO NOT press the dome cover from the
top of it as shown in the figure; this might
cause damage to the Dome Camera.
STEP 6
Screw the dome cover and camera body
together with the supplied M3 Standard/
Security Screw. For fastening the Security
Screw, please use the supplied Security
Torx.
STEP 7
Then tighten the two Slotted Screws on
the camera housing as shown in the figure
by turning them counterclockwise.
TEP 8
Set the switches located on the bottom of
the Dome Camera.
CAMERA SETUPS AND CABLE CONNECTIONS
CAMERA SETUPS AND CABLE CONNECTIONS
Summary of Contents for ISE-XH12ZWDN650 FD
Page 35: ...www infinity cctv com ...
