Infinity ISE-12ZWDN650 FD, Operating Instructions Manual

Page: 23 / 37

42 | ISE-12ZWDN650 FD ISE-12ZWDN650 FD | 43
ENG
Switch No. Protocol Baud Rate
0 VCL 9600
1 Pelco D 2400
2 Pelco P 4800
4 Chiper 9600
5 Philips 9600
7 DSCP 9600
8 AD422 4800
9 DM P 9600
11 Pelco D 4800
12 Pelco D 9600
13 Pelco P 2400
14 Pelco P 9600
15 JVC 9600
21 Kalatel-485 9600
22 Kalatel-422 4800
23 Panasonic 19200
Use the 6-bit dip switch (Camera Control Protocol Switch) to set your camera’s control protocol and its baud rate.
If select protocol: Pelco D, which is of switch no. 01 and baud rate 2400, for instance, set the SW 6 to “ON,” with
the rest to “OFF,” as shown below.
The Dome Camera is supplied with one integrated 22-pin Data Cable for connecting with the power, video, and
RS-485/audio input & audio output cables. Please read the following sections thoroughly before making
connections.
6.2
CABLES AND CONNECTIONS
For operation, the Integrated High Speed Dome Cameras require video, RS- 485 and power cables as described
below:
The video cable sends video signals to a remote viewing site. Using a coaxial cable to send video signals is •
recommended.
RS-485 cable carries commands from a control device to the Dome Cameras. A CAT 5, 24 gauge cable is rec-
•
ommended.
Power supply: DC 12V/AC 24V output voltage
•
Note: Ensure power supply meets the Dome Camera’s power requirement, or product impairment will occur.
If any mistake happens, please contact with a qualified maintenance engineer.
The analog Speed Dome Cameras’ Data Cables are illustrated as follows.
6.2.1
CABLE REQUIREMENTS
6.2.2
22-PIN DATA CABLE
Note: Be careful not to pull the cables improperly during installation. Additionally, it is suggested to fasten
the cables after cable connection is completed. Furthermore, when wiring the power cable, make sure the
Ground wire inserted into the mid-pin of the terminal block.
DC 12V Data Cable
AC 24V Data Cable
CAMERA SETUPS AND CABLE CONNECTIONS CAMERA SETUPS AND CABLE CONNECTIONS