Infinity 890 HD, Instruction For User, Installation & Servicing, Page: 13 / 60

P a g e | 12
LT7593 Issue No 1 (03/2017)
890 HD USERS INSTRUCTIONS
WALNUT FUEL BED LAYOUT
Place a single layer of the forge embers across the burner spreading them out evenly
Note: by applying more than one layer may result in excessive sooting and produce a
poor flame picture
Stretch out the Embaglow fibers out so that they form a loose and thin network then lay the
network across the back of the layer of forge embers, try and ensure that there is no clumps of
the fibers to allow the gas to flow through. Please note that these fibers are made of metal and
must be kept away from the pilot so it does not short and prevent the pilot from lighting
Lay a single layer of the bark chippings across the front edge of the air tray as shown in the
image above