3) The heater must not be located immediately below a socket –
outlet.
4) Do not use this heater with a programmer, timer or any other
device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly
5) Do not use this heater in the immediate surroundings of a bath,
a shower or swimming pool
6) The fireguard does not give full protection for young children
and for infirm persons
The appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Assembly.
Follow instructions for assembly.
1)
Remove butterfly nuts form the base.
2)
Pull the power cord through the base plate and place the cord
through the cable channel to ensure that it is secure.
3)
Ensure that the base plate is firmly in position and then gently
screw the butterfly nuts into position and secure firmly.
Operation.
1)
Insert plug into socket
2)
Set the power supply switch (orange colour) to the “ON”
position. This will enable the upper and middle heating tube to
start. To control the other tubes use switches 2 and 3 To allow
the heater to oscillate please press the ‘TURN’
