Infinition Inc. Rev. 02
12
Standard deviation
- A number used to tell how measurements for a group are spread out from the average,
or expected value. A low standard deviation means that most of the numbers are very close to the average. A
high standard deviation means that the numbers are spread out.
Lowest:
The lowest Velocity of the current Series.
Highest:
The highest Velocity of the current Series.
Average:
The average Velocity of all shots in the current Series.
5.
Maintenance
The LabRadar radar does not require much maintenance. Attention should however be paid to a few
points:
-
Keep the connectors clean from dirt and moisture to avoid corrosion and bad connections.
-
Now and then wipe the radar enclosure with a soft and wet cloth.
-
The circuits are protected by a plastic enclosure. Special attention should be paid when handling the
radar to avoid damaging the plastic enclosure as it could result in performance degradation.
6.
USB Connector Specification
Connector type: USB micro Type A female on unit
7.
SD Card Connector
Connector type: SD Card Socket (Standard)
8.
Trigger Input Connector
Connector type: Stereo 1/8” stereo audio jack with specific pinout
(Do not connect headphones)
Safety Information:
1.
Always keep the weapon pointed in a safe direction, and keep your finger off the
trigger, until you are ready to shoot.
2.
Firearms should be unloaded and securely stored when not in use.
3.
Be sure of your target and backstop before you shoot.
4.
Wear shooting glasses and ear protection when you shoot.
5.
Don’t shoot at a hard surface or at water.
6.
Avoid alcoholic beverages or drugs when shooting or handling a weapon.
7.
The launching of any projectile involves risk of injury/death to persons and damage to
property. You are responsible for any such actions and their consequences.
8.
Always place LabRadar in a safe position to avoid damage to the unit.
All these important safety rules
must
be followed at all times by persons handling any
weapon.
Warning: No operator serviceable parts inside the radar unit. Please refer
servicing to service qualified personnel
!