22
23
Switching Off the Signal Tone
The signal tone can be switched on and off. For this, press the metaldetection button
5
and the wood-detection button
4
at the same time. When the signal tone is switched
off, the switched-off audio signal indicator
j
appears on the display.
The signal tone setting is maintained after switching the measuring tool off and on
again.
“AutoCal” Calibration Indicator
When the check mark behind the “AutoCal” calibration indicator
g
flashes over a
longer period or if it is not displayed anymore, reliable scanning is no longer possible.
MAINTENANCE AND SERVICE
Maintenance and Cleaning
When the measuring indicator f continuously shows an amplitude even though there
is no metal object in the vicinity of the measuring tool, the measuring tool can be
calibrated manually. For this, remove all objects in the vicinity of the measuring tool
(including wrist watches or rings of metal) and hold the measuring tool up in the
air. With the measuring tool switched off, press both the “on/off” button
6
and the
wood-detection button
4
until the illuminated ring
1
lights up red and green at the
same time. Then release both buttons. When the calibration process was successful,
the measuring tool will start over after a few seconds and is then ready for operation.
Wipe away debris or contamination with a dry, soft cloth. Do not use cleaning agents
or solvents. In order not to affect the measuring function, decals/stickers or name
plates, especially metal ones, may not be attached in the sensor area
8
on the front
or back side of the measuring tool.
Do not remove the felt pads
7
on the back side of the measuring tool. Replace the felt
pads when they are damaged or used. For this, completely remove the felt pads and
glue the new felt pads onto the same spots.
Store and transport the measuring tool only in the supplied protective case.
Spare Parts
Protective case
Battery lid
9
Felt pads
7
DISPOSAL
Measuring tools, accessories and packaging should be sorted for environmental-
friendly recycling.
Only for EC countries:
Do not dispose of measuring tools into household waste! According
the European Guideline 2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national right, measuring tools
that are no longer usable must be collected separately and disposed
of in an environmentally correct manner.
Battery packs/batteries:
Do not dispose of battery packs/batteries into household waste, fire or water. Battery
packs/batteries should be collected, recycled or disposed of in an environmental-
friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be recycled according the
guideline 91/157/EEC.
Subject to change without notice.
Service and Customer Assistance
www.condtrol.com