3
Pre-Install Notes
READ ALL WARNINGS BEFORE ANY SERVICE OR TESTING
Do not install, make any adjustments, or replace any components inside the
enclosure with the power supply turned on. Under certain circumstances,
dangerous potentials may exist even when the power supply is off. To avoid
casualties, always turn the main power supply off before performing maintenance
and/or testing.
HAZARD OF ELECTRIC SHOCK, BURN, OR EXPLOSION
CAUTION
The installation of a surge protection device (SPD) must be done by qualified
electrical personnel. A SPD must be grounded through the power system ground
for proper operation.
WARNING
Before installing the suppressor, AC power must be OFF. Failure to do so could
result in damage to the suppressor and poses a potential electrical shock hazard to
personnel.Always use a properly rated voltage sensing device to confirm that power
is off.
Read SPD label on side of the enclosure to verify voltage configuration.
Discontinue installation if the measured voltage is not in the range of the model
voltage configuration of the SPD being installed. Contact LEA International
technical support with any questions concerning the voltage configuration prior to
installation and application of power.
Perform such work only after reading and understanding all of the instructions
contained in this manual.
Beware of potential hazards, wear personal protective equipment and take
adequate safety precautions.
Before performing visual inspections, tests, or maintenance on the equipment,
disconnect all sources of electric power. Assume that all circuits are live until they
have been completely de-energized, tested, grounded, and tagged. Pay particular
attention to the design of the power system. Consider all sources of power,
including the possibility of back feeding.
Handle this equipment carefully and install, operate and maintain it correctly in
order for it to function properly. Neglecting fundamental installation and
maintenance requirements may lead to personal injury, as well as damage to
electrical equipment or other property.
Carefully inspect your work area and remove any tools and objects left on /or in the
enclosure.
Replace all devices and covers before turning on the power to this equipment. All
instructions in this manual are written with the assumption that the customer has
taken these measures before performing installation or testing.
Failure to follow these instructions could result in DEATH or
serious injury.
Summary of Contents for LEA INTERNATIONAL LS Plus 200
Page 2: ...2 ...
