InfiniSource ETC 100, Hardware Manual

Page: 52 / 234

40 Infinisource
3. Quickly and evenly slide the card through the card reader slot from
top to bottom.
Note: Proximity time card users need only hold their time card up
to the target located on the right of the face of the clock.
4. The display panel shows the card number of the card just swiped,
and reads
MAKE SELECTIONS
THEN PRESS “ENTER”
5. Press the <ENTER> key on the clock keypad to complete the punch
entry.
Note: The <ENTER> key should always be pressed when complet-
ing a punch at the clock, unless the “Quick Punch” system option is
enabled. See “System Options” on page 47 for a description of
clock options.
Job Tracking Entries
Use the following instructions to enter punches at the time clock which
are assigned to job and task information in the TimeForce system.
1. Check to see if the display panel on the clock reads “READY.” If
the word “READY” is not visible, refer to “Clock Communication
Troubleshooting” on page 169 of this guide.
2. If you are using magnetic time cards, hold the card with the mag-
netic strip facing right. If you are using cards with barcodes, hold
the card with the barcode facing left.
3. Quickly and evenly slide the card through the card reader slot from
top to bottom.
Note: Proximity time card users need only hold their time card up
to the target located on the right of the face of the clock.
4. The display panel shows the card number of the card just swiped,
and reads:
MAKE SELECTIONS
THEN PRESS “ENTER”
5. Press the <JOB> key on the time clock keypad.