XC2000
Easy Kit
Getting Started
XC2000 series Board Manual
27
V 0.2, 2008-11
5
Getting Started
For the successful start up of the XC2000 Easy Kit, the following items should be done:
Figure 15
XC2000 Easy Kit (144-Pin)
By default a HELLO WORLD program can be executed. The following steps are needed
to be successful.
1. Verify that the Jumper JP201 is in position 1-2 (powered via USB).
2. Connect USB cable with starterkit and PC.
3. Install DAS driver from starterkit CD.
4. Verify if the standard start mode is selected as described in chapter 3.1.
5. LED D105 connected with P10.0 should flash, otherwise press the Reset button.
6. Verify which COM port is activated for the FTDI - chip.
7. Execute the monitor program MTTTY from the starterkit CD.
8. Select the corresponding COM port, 19200 Baud, none parity, 8 data Bit, one stop bit,
parser off.
9. Start connection (File/connect).
10.Press Reset button on the starterkit, Hello World program is running .
Summary of Contents for XC2000 Easy Kit
Page 5: ...XC2000 Easy Kit XC2000 series Board Manual 5 V 0 2 2008 11...
Page 36: ......
