Infineon TLE984 Series, Firmware User Manual

Page: 115 / 116

Firmware User Manual (AE-step) 115 Revision 1.02
2019-04-24
TLE984x Firmware User Manual
Appendix G – Change of register reset values
Before the BootROM is executing user code, the startup boot sequence has been executed. This means
configuring the device with user parameters, setting up NVM to be ready for the user and other important
system settings.
Table 6-14 lists the registers, which will be having a different default value than what is
defined in the specification.
Fields marked bold are part of trimming phase.
Table 6-14 Registers with changed default values done by bootROM
Module name
Register name Default reset value Reconfigured value
T21 CON1 0x00000003 0x00000000
T2 CON1 0x00000003 0x00000000
ADC1 CTRL3 0x401 0x400
LS LS1_TRIM 0 Trimming value
LS2_TRIM 0 Trimming value
HS HS1_TRIM 0 Trimming value
HS2_TRIM 0 Trimming value
MF TEMPSENSE_CTRL 0x03 Trimming value
ADC2 CTRL1 0 Trimming value
LIN CTRL 0x180007 0x180207
SCU VTOR 0 0x02
PLL_CON 0xA4 Device variant dependent
APCLK 0 0x1001301
SYSCON0 0x80 0
SYS_STRTUP_STS 0 0x10
OSC_CON 0x10 0x18
NVM_PROT_STS 0 0x403F
SCUPM SYS_SUPPLY_IRQ_CTRL 0xFF 0
Table 6-15 Registers with changed default values done by hardware
Module name
Register name Default reset value Reconfigured value
PMU RESET_STS 0 0x80