4
System and functional description
4.1
Commissioning
4.1.1
Initial setup
The figure below shows an example about how to connect the TLE4972 evaluation boards with the programmer
board via USB connector to a PC or laptop in case of general purpose drive application. Here, the green color
board shown in the figure below could be either of the following boards:
•
Infineon's evaluation board;
•
An user designed generic DUT board.
Interface
cable
Pr
ogr
amm
er boar
d
DUT board
Load
Software GUI
Figure 6
Test setup of TLE4972 DUT board with programmer board
Once the test set up is done, the user has to to connect the programmer board through USB connection
and open the GUI software in order to start the communication with the hardware. If the USB connection is
successful, the LED D1 on the programmer board will light. If the programmer board is correctly recognized
by the GUI, it will appear as "Current Toolbox" in the devices list, as shown in the figure below. Click on the
connection button to start the communication.
TLE4972 Current sensor programmer
User guide
4 System and functional description
User guide
10
Rev. 1.00
2022-04-05
