User guide
8 of 24
V1.0
2021-04-15
EVAL-M7-D111T user guide
iMOTION™ evaluation board for smart driver
System and functional description
2
System and functional description
2.1
Commissioning
2.1.1
Setting up the system
After downloading and installing the iMOTION™ development tools (MCEWizard and MCEDesigner), the following
steps need to be executed to run the motor. Refer to Chapters 2.1.2.1 and 2.1.2.2 as well as to the MCEWizard and
MCEDesigner user guide for more information.
1. Get the latest “IM
D111T
Software Package” available on the www.infineon.com/imotion
-software website.
2. Connect PC and evaluation board via USB cable or iMOTION
TM
link.
3. Connect the AC source and target motor.
4. Use MCEWizard to calculate and create a parameter text file. See chapter MCEWizard setup overview of Chapter
2.1.2.1 for more details.
5. Power-on the system and start MCEDesigner tool to open MCEDesigner default configuration file (.irc) for
IMD111T smart driver.
6. Program the firmware and calculated parameters into the flash. See chapter on MCEDesigner setup overview
of Chapter 2.1.2.2 for more details.
7. After programming successfully, click on the hammer icon to clear the fault signals if there is a red light at the
bottom of MCEDesigner. When the entire system is ready, start the motor by clicking the green traffic light.
Clicking the red traffic light stops the motor.
Figure 3 is an example of the system setup. The control board is EVAL-M7-D111T and power board is EVAL-M7-
HVIGBT-PFCINV.
Figure 3
System setup example
EVAL-M7-HVIGBT-INV
EVAL-M7-D111T