Infineon iMOTION EVAL-M1-183M, User Manual, Page: 8 / 27

User Manual 8 <Revision 1.2>
<2018-06-27>
EVAL-M1-183M User Manual
iMOTION ™ Modular Application Design Kit
Pin assignments
4 Pin assignments
General information about the connectors of the EVAL-M1-183M evaluation board is reported.
Table 3 and Table 4 include the details of JTAG and UART connectors.
Table 3 J2- UART Connector
S. No. Pin Details
1 GND
Ground
2 RXD
Input, Receive data to IRMCF183M, can be configured to GPIO pins
3 TXD
Output, Transmit data from IRMCF183M, can be configured to GPIO pins
4 +3.3V
On board 3.3V supply
Table 4 J1-JTAG Connector
S. No. Pin Details
1 GND
Ground
2 TMS
TMS (test mode)
3 TDO
TDO (data output)
4 TDI
TDI (data input)
5 TCK
TCK (clock)
6 RST
IRMCF183M Reset
7 +3.3V
3.3V power supply(see Specification for max current)
8 VPP
Not Connected
Table 5 provides the pin assignments of the iMOTION ™ MADK-M1 20 pins interface connector J3. This connector
is the interface to the power board.
Table 5 J3- iMOTION ™ MADK-M1 20-pin interface connector for power board
Pin Name Pin Name Connectors
1 PWMUH
3.3 V compatible logic output for high side gate driver-Phase U
2 GND Ground
3 PWMUL
3.3 V compatible logic output for low side gate driver-Phase U
4 GND Ground
5 PWMVH
3.3 V compatible logic output for high side gate driver-Phase V
6 +3.3V
3.3 V supply input
7 PWMVL
3.3 V compatible logic output for low side gate driver-Phase V
8 +3.3V
3.3 V supply input
9 PWMWH
3.3 V compatible logic output for high side gate driver-Phase W
10
IU+ Positive shunt voltage of phase U
11 PWMWL
3.3 V compatible logic output for low side gate driver-Phase W
12 IU-
Negative Shunt voltage of phase U or Ground if using single end current
feedback
13 GK
Gate kill signal – active low when over current is detected