Striker HD
-User’s Guide
Install Striker HD on a hard flat surface not prone to vibration or impact and not on top of
another electronic device
Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
Installation of Striker HD near consumer electronics devices, such as stereo
receiver/amplifiers and televisions, is permitted as long as the air surrounding Striker HD
does not exceed 40º C (104º F).
Do not install Striker HD in an area where condensation occurs.
To prevent the temporary loss of guide data and cause a temporarily non-responding Striker
HD, do not plug the AC power cord into a switched power outlet.
FCC COMPLIANCE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and set-top box.
Connect the equipment into an outlet on a circuit different from that to which the set-top box is connected.
Consult the dealer or an experienced radio/TV technician for help.
4/ 36
