Upper anchorage strap and attachment clip
must always be used
Upper Anchorage strap and attachment
clip must only be attached to the correct
anchor fitting
Always ensure that the upper attachment clip
is correctly engaged to the anchor fitting
Straps may be damaged by unsecured cargo
in a collision. Secure or remove hazardous
cargo before using this strap in a Hatch-Back
or wagon
Do not use the child restraint where the
anchorage strap may fall into a split in
the seat back
Always attach hook and remove slack
Some vehicles may have an anchor fitting already
fitted by the vehicle manufacturer.
If no anchorage points can be found refer to
the vehicle manufacturer, or an authorised child
restraint fitting station for the best location of an
anchorage point.
Refer to the vehicle owners handbook or child
restraint fitting station for the possible use of
spacers.
Some vehicles may require the use of additional
extension straps (not supplied with this child
restraint)
If so ring InfaSecure on (Aust) (02) 4728 8080 for
nearest supply location.
ADDITIONAL EXTENSION STRAPS AVAILABLE:
CS111 300mm Extension strap
CS112 600mm Extension strap
CS113 200 - 900mm Adjustable Extension strap
FOR CARS FITTED WITH A CHILD RESTRAINT ANCHORAGE POINT
LOCATE THE ANCHORAGE POINT BEHIND THE REAR SEATING POSITION
CONSULT THE CAR OWNER’S HANDBOOK FOR LOCATION OF ANCHORAGE POINTS.
REMOVE THE THREAD PLUG FROM THE PARCEL SHELF/FLOOR/ROOF AND INSTALL THE ATTACHMENT
BOLT AS SHOWN IN FIGURE 1A & 1B.
UPPER ANCHORAGE FITTINGS
Attachment Bolt
THIS RESTRAINT MUST BE ATTACHED TO A CHILD RESTRAINT ANCHORAGE POINT IN THE CAR.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT
BOLT. MAXIMUM TORQUE IS 20NM.
WARNING
!
3