background image

7.

5. 

Pull the webbing strap on the 

Back/Chest Strap

 to 

tighten. The 

Shoulder Straps

 should be wide and the 

Back/Chest Strap

 should be straight across your back. 

 

* NOTE: The height of the 

Back/Chest Strap

 can be adjusted 

by sliding the 

Back/Chest Strap

 to the desired height. The 

strap should lay in a comfortable position on your upper back.

6. 

Fasten the 

Waist Belt & Buckle

 around your waist and 

pull the webbing to tighten. 

 

*NOTE: People with longer torsos may find a higher belt 

position more comfortable (closer to the navel); shorter people 

may wish to wear the belt more on the hips. 

* IMPORTANT! ALWAYS ensure that the 

Waist Belt

 fits 

securely against your body at all times without creating a gap. 

 

 

 

 

 

 

 

 

7. 

Fasten the 

Side Closure Buckle 

on one side. This step 

will create a 

Leg Opening

 on the closed side. 

 

 

 

 

 

 

 

 

 

8. 

With the carrier open on one side and the baby facing 

you, carefully slide the baby into the carrier by fitting his/

her leg through the 

Leg Opening

 on the closed side of 

the carrier. 

 

*IMPORTANT! Keep one hand on the baby until all buckles  

and straps are properly fastened. 

*Make sure your baby’s leg goes through the

 Leg Opening

 on 

the closed side of the carrier. 

 

 

 

CORRECT

INCORRECT

8.

9. 

While supporting the baby with one hand, fasten the 

other

 Side Closure Buckle

.  

 

 

 

 

 

10. 

Support the baby’s head by attaching the two

 Head 

Support Buckles

 above each arm. Adjust the size of 

the 

Head Support

 by pulling both of the 

Head Support 

Straps

 

*IMPORTANT! Always make sure there is enough room around your baby’s 

face to provide a clear source of air. 

 

 

 

 

11. 

Attach the

 Leg Strap

 to the 

Leg Strap Button

 on BOTH 

SIDES of the carrier.

 

 

*IMPORTANT!  For babies between 8-11 lbs (3.6-5 kgs), the 

Leg Straps

 

must be  attached to make the leg opening smaller and to avoid a 

potential falling hazard.*NOTE:  For babies over 11 lbs (5 kg), this step is 

unnecessary. 

 

 

 

 

12. 

To adjust how high the baby rides on your chest, lift the 

baby slightly and pull the 

Shoulder Strap Adjuster

, first 

on one strap, then on the other. The 

Shoulder Strap 

Adjusters

 should be equal lengths after adjusting. 

When the baby is properly positioned you should be 

able to tilt your head forward and kiss the top of your 

baby’s head.

 

 

*NOTE: Wearing the carrier closer to your body and higher up on your chest 

will minimize stress to your back and shoulders from prolonged use. 

*IMPORTANT: Always make sure baby’s face, nose, and mouth are not 

obstructed. Check your baby’s position regularly. Your baby should be 

centered in the carrier in a seated position with arms and legs extended  and 

not constricted by the carrier. It is extremely important to avoid any slouching 

in baby’s position. A slouching position can restrict baby’s airways. Baby’s 

head should be upright or resting on your chest with the face, nose, and 

mouth positioned to the left or right. Baby’s chin should never rest on baby’s 

chest. This can result in closing or partially closing baby’s airway.

Summary of Contents for Carry On Multi-Pocket Carrier











Reviews: