INETVU® MOBILE SYSTEM QUICK START – COMTECH
C-COM Satellite Systems Inc.
Page 15
5.
Set the 7710 Controller to the same network as the PC and VSAT Modem.
*Note:
The controller IP should be set in the controller through the LCD interface prior to entering
it into the software tool for proper PC to Controller Communication through network interface.
(USB Interface users may skip this step and proceed to the Software installation)
To Configure the IP address on the controller, you must navigate to the CONF menu using the
LCD Interface. (Default password “password”)
a.
Navigate to the “IP” menu and press the “ENTER” button.
b.
Press the ‘↑’ button to allow for modification on the C_IP field and set the IP address
of the controller. For example, if the Modem/Router IP is 192.168.0.1 then the
controller IP could be set to 192.168.0.2. Press the “ENTER” button once the change
is complete.
c.
Press the “Exit” button twice to exit out of the configuration menu. When prompted if
you would like to save configuration, press the ‘↑’ button to select “Y” (yes) and press
“Enter”.
d.
Click the “reset” button on the controller.
You may view the 7710 Controller IP from the LCD interface via – MONITOR
IP
(C_IP)
1.10 Software Installation
Please Note:
Do not connect the Controller via USB until the drivers and software have been installed
1.
If you are installing from the USB flash drive or have downloaded from the C-COM FTP, run the
iNetVu7710Setup.exe
file.
SAT MDM EL AZ PL GP
MT CC PW SG IP SR
C_IP: 192.168.000.002
M_IP: 192.168.000.001
