Assembly instructions
Safety rules:
This product should only be installed by qualified personnel.
1.
Roller blind weight cannot exceed the maximum working load of the
drive, as expressed in selection table.
2.
Appropriate positioning of the cable protects the drive from being
damaged by water.
3.
Do not puncture the engine along its entire length.
4.
Protect the engine from contact with liquids of any kind.
5.
Protect the engine from crushing, falling and do not subject it to shock.
6.
Do not connect more then one manual switch to one motor.
Motor assembly
Fix mounting bracket (
A)
to the side of the roller blind, connect adapter with engine drive ring (
C/D
).
Place the special driver attached to the engine (
E
) on the engine axis and secure with clip (
E/F
). Insert the
entire engine into the winding pipe (
G
).
Connect winding pipe and dricer with screws or rivets (
H
).
CAUTION!
Engine is equipped with internal thermal switch, which allows for about 4 minutes of constant work.
Afterwards the temperature within the engine exceed the maximum limit value, which will result in power
supply being cut off. Roller blind can be moved again once the engine has cooled off (which might take
several minutes). This solution serves to prolong the life of the drive.
Electrical connection
Switch the power off prior to making electrical connections of any sort.
Yellow/ green (PE protective)
Blue
(N neutral)
Brown (L1 phase up direction)
Black (L1 phase down direction)
Grey (disconnected)
INCORRECT ASSEMBLY MAY RESULT IN UNCONTROLLABLE STOPPING OF THE MOTOR
Conditions necessary for proper functioning of obstacle detector:
1.
Use of the special driver attached to the motor.
2.
Free movement of roller armouring in guide rails and casing under gravity; the motion cannot
be disturbed (abrasion of roller casing, mosquito net, etc.)
3.
Weighting down the lower strip (with band iron, for example).
4.
Connecting the opposite sides of the driver to the winding pipe with two screws/bolts/rivets.
No need for locks or stoppers.
