Ref. 006001001300
Rev. 0: 30-08-2019
1. SCL-D3/Q0.6 – Choosing between SCL (I2C) and Q0.6. If this switch is ON, the Q0.6 input will
be enabled and the SCL will be disabled. If this switch is OFF, the SCL will be now available and
Q0.6 disabled.
TOP ZONE
NOTE: Although in the TOP ZONE serigraphy it is shown Q0.9 & Q0.8 pins, in the reality they
are I0.3 I0.2 pins respectively. Additionally although the serigraphy only is expressed for the
RS485 it is also the same for the RS232. So if it is desired to enable any of the Hardware Serial
connection this is the function of these switches. See chapter 8 for more information
1.
I0.3: If this switch is ON, the RS485/RS232 HS switch must be set to OFF. Being in ON
mode it enables I0.3.
2.
RS485/RS232 HS: If this switch is ON, the I0.3 switch must be set to OFF. Being in ON
mode it enables the D0 for the RS-485 or RS-232 Hardware Serial (see section 9 for
jumper configuration)
3.
I0.2: If this switch is ON, the RS485 switch must be set to OFF. Being in ON mode it
enables I0.2.
4.
RS485/RS232 HS: If this switch is ON, the I0.2 switch must be set to OFF. Being in ON
mode it enables the D1 for the RS485 or RS-232 Hardware Serial (see section 9 for
jumper configuration)
TOP ZONE
SWITCH
OFF
ON
I0.3
RS485/RS232 HS
I0.3
RS485/RS232 HS
I0.3
RS485/RS232 HS
I0.2
RS485/RS232 HS
I0.2
RS485/RS232 HS
I0.2
RS485/RS232 HS
I0.3
RS485/RS232 HS
I0.2 RS485/RS232 HS
Summary of Contents for PLC Arduino ARDBOX
