PAG 9
Instructions Manual
INSTALLER MANUAL
Installation and setup
NOTE:
The warranty does not cover problems caused by equipment or defective changes
that are not performed by qualified personnel
Instructions Manual
PAG 10
INSTALLER MANUAL
Installation and setup
MODEL
TIPE
COLOR
V
Hz Nominal Power
Category
Nominal Pressure
Nominal Thermal Use
Power supply:
For your safety, when installed the
appliance, must be electrically grounded
in accordance with local codes. This
connection should be performed by a
qualified electrician.
Check on the identification plate which is
located in the back of your stove to see the
appropriate voltage and power supply for
your installation.
Be sure the outlet is energized by plugging
in a lamp and turning it on.
Plug the service cord of your stove to the
outlet.
All operations in the installer manual must be carried out by
qualified personnel.
a
b
d
c
e
ELECTRIC SHOCK
RISK
WARNING
• Do not use extension cords.
• Do not use the product without grounding.
• Do not use adapters or T's.
• Disconnect power before servicing.
• Replace all parts and panels before operating.
• Do not remove the grounding terminal.
• Connect the terminal to an effective ground connection.
• If the power cord is damaged, it must be replaced by the
manufacturer, after-sales service, or by a similar qualified
personnel to prevent accidents.
• Failure to follow these instructions can bring
life-threatening, fire or electric shock accidents.
Be sure service cord never goes near of heat sources
and located at the same side of the power supply. In
particular consider doors and external surfaces
temperature of the appliance may be high when it is
operating.
Electrical installation.
If the appliance has electrical elements, follow the instructions below for
installation.
Connectors for wood (In reference).
•For some models cooking, take the cable from the
back of the appliance and connect it to the
grounding installation.
•Make sure the voltage of the outlet connection of
the electrical installation is in accordance with the
rated voltage of the appliance.
•In the control box of the electric power house,
identify the breakers that control the appliance,
mark with the name and eventually connect it to
the outlet.
IMPORTANT:
If the geometry of the appliance plug does not match the outlet of the
installation, change one of them so that both match, ensuring that the plug or
receptacle meets the electrical specifications of the engine.
The function of the grounding cable is to evacuate
the small leakage currents in electrical devices and
provide user protection against over voltage short
circuit, for kitchens is very important prior connection,
which should be the connection circuit to earth on
the electrical system of the building or alternatively to
a metal water pipe, metal underground structure or
local system. Appliances have recessed grounding
wire built into current input and require no additional
connection.
ELECTRIC SHOCK
RISK
ATTENTION
APPLIANCE
Flat connector straight
(110V)
Three wire connector
(110V/220V/240V)
Locked leg type connector
(208V/220V/240V)
Connector type C
(220V) Valid for Peru
