39
• DOK-DIAX01-TDA********-PRJ1-EN-E1,44 • 07.97
7. Assembly
Installing the modular main
spindle controller in the
control cabinet
7. Assembly
Geräteeinbau
The mounting plate in the control cabinet or the rear wall of the cabinet
must have three M6 tapped holes according to Section 2.2, Fig. 9. Take
care to observe the correct mounting clearance to the next unit! The units
must always be mounted in vertical position!
First screw in three socket head cap screws M6 - DIN 912 (Allen screws)
far enough into the holes so that they cannot fall out.
Tip the controller forwards and let it first engage with the lower two Allen
screws.
Then push the controller back against the rear wall, raising it slightly until
the upper mounting hole engages with the top Allen screw.
Now tighten all screws!
The controller mounting is illustrated in perspective in Fig. 27 (installation
sketch).
An Allen screw driver with a shaft length of more than 400 mm
is a great help when mounting the controller!
The controller should already be fitted with the programming module
AS 7 •/ • • • – • • • on installation. This is plugged into the upper right corner
of the TDA 1 and secured with a knurled screw!
Before commissioning the TDA 1, the programming module
must be in place and securely held by a knurled screw.
