11
• DOK-DIAX01-TDA********-PRJ1-EN-E1,44 • 07.97
1. Presentation of the modular main spindle controller TDA 1
The controller TDA 1 has been designed to operate with parameters.
Parameter values are used to match the controller to the main spindle
motor, the machine conditions and the requirements of the application.
Parameters
Fig. 4: Designation of TDA 1 features
Control voltage bus, design.
Digital position command, design.
Earth connection
Incremental encoder output, design.
Interfaces, feedback
Interfaces, NC control unit
Motor feedback connection, design.
Motor thermistor connection, design.
Position command design.
Programming module, design.
Ready contact, design.
Serial interface, design.
Signal outputs, design.
Speed command, design.
Standard interface, design.
Synchronization input, design.
Terminal block for motor and DC link
Typisierung:
Fertigungsnummer:
X1
ATTENTION!
BLOWER SUPPLY VOLTAGE
Lüfterspanngung
220VAC
X8
L+
L-
A3
A2
A1
DANGER HIGH VOL
T
AGE
AC - MAINSPINDEL DRIVE
READY
FAULT
X11
Bb Bb
X3
X5
X2
X4
Parameter
MOT
OR POWER OUTPUT
Motoranschluß
1 2 3
T1 T2
X12
SWITCH OFF
VOLTAGE BEFORE
CHANGING MODULE
AS
Prog. Modul AS
nicht unter
Spannung wechseln
DANGER POWER
300 VDC INPUT
DISCHARGE TIME
Entladezeit > 1 Min.
POWER SUPPLY OUTPUT
VOLTAGE RATING, MUST
NOT EXCEED POWER
INPUT VOLTAGE DATA
Nur mit Versorgungsein-
heit gleicher od. kleinerer
POWER-Spannungs-
angabe betreiben
Motor:
Contr
.:
Software:
Parameter: Serien-Nr
.:
Earth connection
Programming module AS 7
Motor thermistor
connection
Terminal block
for motor and
d.c. link circuit
Control panel
Connection for
"ready" contact
Additional interface (X6, optional)
- digital position set-point, 16 bit parallel
- incremental encoder output
- serial interface RS 232C
Interfaces for NC:
• Control inputs,
signal and analogue outputs
(X2, standard interface)
• Speed command value (X4)
- analogue
±
10V (optional)
- digital 16 bit parallel (optional)
- Sercos interface (optional)
Interfaces for feedback:
• Motor feedback connection
(X3)
• Additional encoder input for
spindle feedback or second
motor feedback signal (X5, optional)
• Synch. input for
master spindle feedback
(X5a, optional)
Front.FH3
X5a
Connection
for control
voltage bus
