ANT+ CONSOLE
Copyright by Indoorcycling Group GmbH 2013 | www.indoorcycling.com
09
EN
G
BASIC SETTINGS
BASIC SETTINGS
Basic settings must be done during the assembly
process. Before you start with the basic settings,
make sure everything is assembled properly to
the bike or KRANKcycle.
Basic settings include:
• Pairing of ANT+ RPM transmission.
• KM/MILE settings.
• Gear Ratio settings.
Basic settings process:
• Press any button and insert batteries into the
ANT+ console to enter maintenance mode.
• Press “SUN” button to display software version.
• Press “SUN” button to enter ANT+ RPM pairing
mode.
•
Press “FLOW” button to start ANT+ RPM
pairing.
(Put the console as close as possible to the transmitter and
provide RPM signal during the pairing process).
As soon as a RPM signal is displayed, pairing of
ANT+ RPM transmission is finished.
Proceed with basic settings process:
• Press “SUN” button to enter KM/MILE setting.
• Press “FLOW” button to select between KM or
MILES.
• Press “SUN” button to confirm your selection
and to enter gear ratio settings.
• Press “FLOW” button to select between
following gear ratios:
- 1:3.1 for bikes with V-Belt Drive. (IC3, S-/E-Series).
- 1:4.0 for bikes with Timing-Belt Drive.
- 1:4.3 for KRANKcycle.
• Press “SUN” button to confirm your selection
and finish the basic settings process.
