User Guide - v1-Draft 1
20
•
Sub Stream
— Configure the Sub Stream to be sent using Multicast for the selected
input channel.
•
Enable
— Select this option to enable the Sub Stream to be sent for the channel.
•
Sub Stream
— Enter the IP address to be used for sending the Sub Stream using
Multicast.
•
Port
— Enter the port number to be used for sending the Sub Stream using
Multicast.
Click
Refresh
to undo the changes you have made in this page.
Click
Default
to restore all fields in the page to their default settings.
Click
Save
to apply any changes you have made.
Event
These pages allow you to configure the Event detection and Alarm settings for the BX 8/16
Channel Encoder.
Video Detection
Use this page to configure the Video Detection settings for the BX 8/16 Channel Encoder.
On the
Motion Detection
,
Video Loss
,
Video Tamper
, and
Diagnosis
tabs, you can setup
actions to be taken when motion, loss of video, tampering or camera errors are detected by
the encoder.
•
Enable
— Select the checkbox to enable detection, and select a Channel for
configuration from the dropdown.
Click
Set
to configure the types and severity of error which should trigger a detection
on that Channel, using the checkboxes and sliders in the popup displayed (Diagnosis
only).
•
Period
— Click
Set
to configure the active time periods on the selected Channel.
You can set a maximum of 6 active periods for each day. Configure the active periods
using the visual display with the checkboxes and entry fields below the display. In the
visual display, green bars indicate the active periods for each day of the week.
•
Click
Set
next to the day where you want to configure the active periods.
The day being configured is highlighted in red and the checkbox for that day is
automatically selected below the display.
•
Select additional checkboxes or
All
below the display to configure the same active
periods for several days.
•
Click on a green bar for that day to remove it, or click and drag in the area below the
bar to add an active period.
As you configure the active periods, they are reflected in the entry fields below the
visual display.
Click
Default
to restore all active periods to their default settings.
Click
Save
to apply any changes you have made.
Click
Cancel
to cancel the changes you have made to active periods.
•
Anti-dither
— Enter a time in seconds of
0
to
600
, in which the encoder will only
recognize a single detection.
•
Sensitivity
— Use the dropdown to configure the tamper sensitivity from
1
to
6
where
higher values represent increased sensitivity (Video Tamper only).
•
Region
— Click
Set
to configure the image regions where detection is used on the
selected Channel.
8/16 Channel Encoder - BX Range
5 Web configuration pages