Indesit VIA640C, Service Information

Page: 28 / 29

28 of 29
Service Manual UK
Indesit Company
English
METHOD 2 - ALL OTHER SUITABLY QUALIFIED PERSONS
The appliance can be programmed using a Smartcard Reader (Part No. C00263927) and a Smartcard
preprogrammed to the relevant model.
1. Disconnect the appliance from the electrical supply.
2. Insert the pre-programmed card into the Card Reader. Care must be taken at this point to ensure
the card is inserted correctly with the Chip on the card facing the PCB of the Reader.
3. Insert the Reader AND Card into the Serial Port.
4. Connect the appliance to the electrical supply and the LEDs on the Smart Card Reader will light
with this sequence.
a)
Red ON: Good Communication between Smart Card Reader and Card.
b) Red OFF: Green Blinking: Download taking place.
c) On completion: Green ON---> Download OK.
d) On completion Red ON or Red flashing--->Download NOT OK - also see note below.
5. Programme complete, disconnect the machine from the electrical supply.
6. Remove the Smart Card Reader.
Note:
If the Red LED is flashing slowly - a Smart Card is inserted but either:
a) The card is BLANK or previously used (it is erased after a successful download).
b) Is incorrectly inserted - maybe the wrong way round.
c) There is a poor connection between the card and reader.
If the Red LED is flashing rapidly, a card is not inserted or inserted fully.
After successfully downloading the file to the appliance, ensure it is disconnected from the mains
supply for 30 seconds before attempting to use it.