GB
5
V
The hob burners do not require primary air adjustment.
After adjusting the appliance so it may be used
with a different type of gas, replace the old rating
label with a new one that corresponds to the new
type of gas (these labels are available from
Authorised Technical Assistance Centres).
Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet hose in
accordance with current national regulations relating
to regulators for channelled gas.
A
dapting
the
o
v
en
Replacing the oven burner nozzle
1. open the oven door fully
2. pull out the sliding oven
bottom
3. unscrew the burner
fastening screws
4. remove screw
V
and then
the oven burner;
5. Unscrew the oven burner
nozzle using the special
socket spanner for the
nozzles, or a 7 mm socket
spanner, and replace it with a
nozzle suited to the new type
of gas (see Table 1).
Take particular care
handling the spark plug wires and the
thermocouple pipes.
6. Replace all the parts, following the steps
described above in the reverse order..
A
d
j
usting
the
gas
o
v
en
b
urner
s
minimum
setting
:
1. Light the burner (
see Start-up and Use
).
2. Turn the knob to the minimum position (MIN) after
it has been in the maximum position (MAX) for
approximately 10 minutes.
3. Remove the knob.
4. Tighten or loosen the adjustment screws on the
outside of the thermostat pin (
see figure
) until the
flame is small but steady.
If the appliance is connected to liquid gas, the
adjustment screw must be fastened as tightly as
possible.
5. Turn the knob from the MAX position to the MIN
position quickly or open and shut the oven door,
making sure that the burner is not extinguished.
A
dapting
the
grill
Replacing the grill burner nozzle:
1. Remove the oven burner
after loosening screw V (
see
figure
).
2. Unscrew the grill burner
nozzle using a special nozzle
socket spanner (
see figure
) or
preferably with a 7 mm socket
spanner, and replace it with a
new nozzle that is suited to the
new type of gas (
see Burner
and nozzle specifications table
).
Be careful of the spark plug wires and the
thermocouple tubes.
The oven and grill burners do not require primary
air adjustment.
After adjusting the appliance so it may be used
with a different type of gas, replace the old rating
label with a new one that corresponds to the new
type of gas (these labels are available from
Authorised Technical Assistance Centres).
Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet hose in
accordance with current national regulations relating
to regulators for channelled gas.
V
I
