background image

4

Health & Safety guide

electrical connections, and repairs must be carried 

out by a qualified technician . Do not repair or replace 

any part of the appliance unless specifically stated in 

the user manual . Keep children away from the 

installation site . After unpacking the appliance, make 

sure that it has not been damaged during transport . 

In the event of problems, contact the dealer or your 

nearest After-sales Service . Once installed, packaging 

waste (plastic, styrofoam parts etc .) must be stored 

out of reach of children  - risk of suffocation . The 

appliance must be disconnected from the power 

supply before any installation operation  - risk of 

electric shock . During installation, make sure the 

appliance does not damage the power cable - risk of 

fire or electric shock . Only activate the appliance 

when the installation has been completed .

 Be careful not to damage the floors (e .g . parquet) 

when moving the appliance . Install the appliance on 

a floor or support strong enough to take its weight 

and in a place suitable for its size and use . Make sure 

the appliance is not near a heat source and that the 

four feet are stable and resting on the floor, adjusting 

them as required, and check that the appliance is 

perfectly level using a spirit level . Wait at least two 

hours before switching the appliance on, to ensure 

that the refrigerant circuit is fully efficient .

 To guarantee adequate ventilation, leave a space 

on both sides and above the appliance . The distance 

between the rear of the appliance and the wall 

behind the appliance should be 50  mm, to avoid 

access to hot surfaces . A reduction of this space will 

increase the Energy consumption of product .

 WARNING: To avoid a hazard due to instability, 

positioning or fixing of the appliance must be done 

in accordance with the manufacturer instructions . It 

is forbidden to place the refrigerator in such way 

that the metal hose of gas stove, metal gas or water 

pipes, or electrical wires are in contact with the 

refrigerator back wall (condenser coil) .

ELECTRICAL WARNINGS

 It must be possible to disconnect the appliance 

from the power supply by unplugging it if plug is 

accessible, or by a multi-pole switch installed 

upstream of the socket in accordance with the 

wiring rules and the appliance must be earthed in 

conformity with national electrical safety standards .

 Do not use extension leads, multiple sockets or 

adapters . The electrical components must not be 

accessible to the user after installation . Do not use 

the appliance when you are wet or barefoot . Do not 

operate this appliance if it has a damaged power 

cable or plug, if it is not working properly, or if it has 

been damaged or dropped .

 If the supply cord is damaged, it must be replaced 

with an identical one by the manufacturer, its service 

agent or similarly qualified persons in order to avoid 

a hazard - risk of electric shock .

CLEANING AND MAINTENANCE

 WARNING: Ensure that the appliance is switched 

off and disconnected from the power supply before 

performing any maintenance operation; never use 

steam cleaning equipment - risk of electric shock .

 Do not use abrasive or harsh cleaners such as 

window sprays, scouring cleansers, flammable 

fluids, cleaning waxes, concentrated detergents, 

bleaches or cleansers containing petroleum 

products on plastic parts, interior and door liners or 

gaskets . Do not use paper towels, scouring pads, or 

other harsh cleaning tools .

DISPOSAL OF PACKAGING MATERIALS

The packaging material is 100% recyclable and is marked with the recycle 

symbol 

  .

The various parts of the packaging must therefore be disposed of 

responsibly and in full compliance with local authority regulations 

governing waste disposal .

DISPOSAL OF HOUSEHOLD APPLIANCES

This appliance is manufactured with recyclable or reusable materials . 

Dispose of it in accordance with local waste disposal regulations . 

For further information on the treatment, recovery and recycling of 

household electrical appliances, contact your local authority, the 

collection service for household waste or the store where you purchased 

the appliance . This appliance is marked in compliance with European 

Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE) . 

By ensuring this product is disposed of correctly, you will help prevent 

negative consequences for the environment and human health . 

The symbol   on the product or on the accompanying documentation 

indicates that it should not be treated as domestic waste but must be 

taken to an appropriate collection center for the recycling of electrical 

and electronic equipment .

ENERGY SAVING TIPS

Install the appliance in a dry, well ventilated room far away from any heat 

source (eg . radiator, cooker, etc .) and in a place not exposed directly to 

the sun . If required, use an insulating plate .

To guarantee adequate ventilation follow installation instructions . 

Insufficient ventilation at the back of the product increases energy 

consumption and decreases cooling efficiency .

Frequent door opening might cause an increase in Energy Consumption .

The internal temperature of the appliance and the Energy Consumption 

may be affected also by the ambient temperature, as well as location of 

the appliance . Temperature setting should take into consideration these 

factors .

Reduce door opening to a minimum .

When thawing frozen food, place in the refrigerator . The low temperature 

of the frozen products cools the food in the refrigerator . Allow warm 

food and drinks to cool down before placing in the appliance .

Positioning of the shelves in the refrigerator has no impact on the 

efficient usage of energy . Food should be placed on the shelves in such 

way to ensure proper air circulation (food should not touch each other 

and distance between food and rear wall should be kept) .

You can increase storage capacity of frozen food by removing baskets 

and, if present, Stop Frost shelf .

Do not worry about noises coming from the compressor which are 

described as normal noises in this product’s Quick Guide .

Summary of Contents for F104368













Reviews: