background image

TROUBLESHOOTING

The washer-dryer may occasionally fail to work. Before contacting the Technical Assistance Service, make sure that the problem cannot be easily solved 

using the following list. 

Anomalies

Possible causes / Solution

The washer-dryer does not 

start.

The appliance is not plugged into the socket, or not sufficiently to make contact.
There is no power in the house.

The wash cycle does not start.

The washer-dryer door is not closed properly.
The ON/OFF

 

 button has not been pressed.

The START/PAUSE   button has not been pressed.
The water tap has not been opened.
A delay has been set for the start time.

The machine does not fill with 

water or the indicator light 

for the first wash cycle stage 

flashes rapidly.

The water inlet hose is not connected to the tap.
The hose is bent.
The water tap has not been opened.
There is no water supply in the house.
The pressure is too low.
The START/PAUSE   button has not been pressed.

The washer-dryer 

continuously loads and 

unloads water.

The drain hose is not fitted between 65 and 100 cm from the floor.
The free end of the hose is immersed in water.
The wall drainage system does not have a breather pipe.
 

If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the 

Technical Assistance Service. If the home is on one of the upper floors of a building, there may be problems relating 

to back-siphonage, causing the washer-dryer to fill with water and drain continuously. Special anti-siphon valves 

are available in shops and help to prevent this inconvenience.

The washer-dryer does not 

drain or spin.

The cycle does not include drainage: with certain cycles it must be started manually.
The drain hose is bent.
The drainage duct is clogged.

The washer-dryer vibrates a 

lot during the spin cycle.

The drum was not unlocked correctly during installation.
The washer-dryer is not level.
The washer-dryer is tucked between furniture cabinets and the wall.

The washer-dryer leaks.

The water inlet hose is not screwed on properly.
The detergent dispenser drawer is obstructed.
The drain hose is not properly attached.

The “Options” indicator lights 

and the START/PAUSE   

indicator light flash, while 

one of the “phase in progress” 

indicator lights and the “door 

locked” indicator light will 

remain lit in a fixed manner.

Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again.  

If the problem persists, contact the Technical Assistance Service .

There is too much foam.

The detergent is not suitable for machine washing (it should be marked with “for washing machine use” or “hand 

wash and machine wash” or similar).
Too much detergent was used.

The wash cycle does not start.

The appliance is not plugged into the socket, or not sufficiently to make contact.
There is no power in the house.
The washer-dryer door is not closed properly.
The ON/OFF

 

 button has not been pressed.

The START/PAUSE   button has not been pressed.
The water tap has not been opened.
A delay has been set for the start time.
The ‘DRYING’ selector knob is in the 

0

 position.

11464730

You can download the Safety Instructions, Product Fiche and Energy data by:

•  Visiting our website - 

http://docs.indesit.eu

•  Using QR Code

•  Alternatively, 

contact our After-sales Service

 (See phone number  in the warranty booklet). When 

contacting our After-sales Service, please state the codes provided on your product’s identification plate.

•  For User’s Repair & Maintenance Information visit www.indesit .com
The model information can be retrieved using the QR-Code reported in the energy label. The label also includes 

the model identifier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu

xxxxxxxxxxxx

 xxxx

Summary of Contents for Ecotime IWDC 65125 UK N

Page 1: ...5 0 80 55 43 4 Cotton 2 40 C 60 C 1200 6 0 3 55 5 0 49 1 40 105 45 5 Silk Delicates 30 C 30 C 0 2 0 0 55 6 Wool 40 C 40 C 800 2 0 1 25 2 0 7 Jeans 40 C 40 C 800 4 0 1 20 4 0 8 Sport Intensive 30 C 30 C 600 3 5 1 25 9 Eco 40 60 1 40 C 40 C 1151 6 0 3 15 5 0 53 1 00 48 33 1151 3 0 2 35 53 0 75 43 36 1151 1 5 2 10 53 0 59 35 33 10 20 C 20 C 20 C 1200 6 0 1 50 5 0 49 0 16 90 22 11 Cotton Dry 0 4 15 5 ...

Page 2: ...that the door is locked To prevent any damage wait until the symbol turns off before opening the door To open the door while a cycle is in progress press the START PAUSE button if the symbol is off the door can be opened FIRST TIME USE Once the appliance has been installed and before it is used for the first time run a wash cycle with detergent and no laundry by setting the 1 cycle DAILY USE Prepa...

Page 3: ... maintenance switch the washer dryer off and disconnect it from the mains power Do not use flammable liquids to clean the washer dryer Clean and maintain your washer dryer periodically at least 4 times per year Disconnect the water and power supplies Close the water tap after every wash This will limit wear on the hydraulic system inside the washer dryer and help to prevent leaks Unplug the washer...

Page 4: ...dryer vibrates a lot during the spin cycle The drum was not unlocked correctly during installation The washer dryer is not level The washer dryer is tucked between furniture cabinets and the wall The washer dryer leaks The water inlet hose is not screwed on properly The detergent dispenser drawer is obstructed The drain hose is not properly attached The Options indicator lights and the START PAUSE...

Reviews: