background image

6. Tandem-specific features

The following chapter is not meant to be a guide for biplace flying. Rather, we would like to address some special 
features of biplace flying that were already taught during the training as a tandem pilot. 

6.1. Harness

The Airtaxi² was tested with harnesses of the LTF type GH and approved with a chest strap width of 46 cm. 
For  biplace  flying,  a  special  biplace  harness  should  be  used  for  the  pilot  due  to  the  rescue  parachute.  Such 
harnesses are optimized for biplace flying in terms of function and comfort.
A harness with a certified protector should always be used for the passenger. Especially "pedestrians" who are flying 
for the first time like to sit down too early during take-off and landing. This risk of injury can be significantly reduced by 
using a harness with a protector. 
In practice, a normal   "solo harness" is often used for the passenger. There is nothing wrong with that. Only the 
rescue parachute has to be removed from the harness so that the passenger does not pull on the deployment handle 
unintended or out of panic during the flight.

6.2. Rescue parachute

For biplace flying a special rescue system is necessary. It must be ensured that the rescue system is approved and 
has at least the same maximum payload as the respective take-off weight. This note is important for the reason that 
most Biplace rescue systems are only approved up to 200 kg, while the Airtaxi² M is approved up to 235 kg take-off 
weight.
A rescue parachute with a smaller maximum payload than the paraglider can be used at any time, but the maximum 
take-off weight is then reduced according to the maximum payload of the rescue parachute!

Under no circumstances may two single-seat rescue parachutes be used whose maximum take-off weight has been 
simply added together. This can lead to uncontrollable situations in case of an emergency release!

6.3. Suspension point rescue parachute

In general, the rescue parachute may only be connected on both sides of the T-bar at the suspension points provided 
for this purpose. The Airtaxi² is delivered with a T-Bar. This already has an integrated reserve bridle (pos. 2), which is 
usually long enough to mount the reserve in the pilot's harness. Attention: the left and right connecting bridle of the T-
Bar must always be connected to the rescue parachute by a suitable connecting link!

If a T-Bar other than the one supplied by the manufacturer is used, make sure that it is type-tested. The eventual 
special attachement point of the rescue reserve can be found in the manual of the T-Bar.

Unsuitable as attachment points/possibilities of the parachute are always:

!

 Attachment to the pilot's harness, since in an emergency the passenger hangs approx. 1 m lower than the pilot and 

the pilot falls with his knees on the passenger's back during an impact.

!

 One-sided mounting, no matter at which point

As a general rule: the installation of the rescue parachute with the harness/T-Bar may only be carried out by a 
qualified person!

6.4. T-bar attachment points

6

7

The T-Bar supplied as standard has the following attachment points:

Pos. 1: Attachment point for the paraglider (karabiner not included)
Pos. 2: fixed connection bridle for the rescue parachute (length 200 cm)
Pos. 3: Attachment point pilot
Pos. 4: Upper attachment point passenger (normal attachment)
Pos. 5: lower attachment point passenger (alternative attachment point for light passengers)

If there is any doubt about which attachment point is chosen for the passenger, this must always be tried out on a 
simulator before the first flight.

6.5. Take-off technique

There are two different, common techniques for take-off:

a) Passenger in front of the pilot:

This take-off technique has the advantage that the pilot, together with the passenger, can build up more tension 
when pulling up the glider. This take-off technique is mainly suitable for stronger winds. When there is little wind, the 
take-off path is naturally longer and fast running one after the other is not possible with this technique. Think also of 
the risk of injury due to accidental kicks by the pilot into the passenger's heel, stumbling or sitting down too early by 
the passenger, who can no longer be "pulled along" by the pilot with this take-off technique. The pilot will then 
probably fall over the passenger without being able to abort the take-off in a controlled manner.

b) Passenger beside the pilot:

As during take-off, the landing can be done much better and more unhindered. This is especially important when 
there is only little headwind. Even in the event of a fall, the pilot does not necessarily fall fully on the passenger, which 
can prevent injuries. If you land beside each other, you have to plan the final approach long enough so that you can 
push the passenger to the side with your leg. This sideways shifting should also remind the passenger that the last 
flight phase has started and he has to raise up. The disadvantage of this method is that the passenger hangs 
sideways, which may cause a slight turn, which has to be corrected with the brake lines.

6.6 Landing technique

As with the take-off, there are two different landing options:

a) Passenger in front of the pilot:

in  case  of  strong  headwinds  this  landing  method  is  easy,  because  there  is  no  need  to  run  out  on  the  ground. 
Otherwise, the same problems can occur as during take-off.

b) Passenger beside the pilot:

As with take-off, you can also run out much better and more unhindered during landing. This is especially important 
when there is only little headwind. Even if the passenger is falling during running, the pilot does not necessarily fall on 
the passenger, which can prevent injuries. If you land beside each other, you have to plan the final approach long 
enough so that you can push the passenger to the side with your leg. This sideways shifting should also remind the 
passenger that the last flight phase has started and he has to stand up. The disadvantage of this method is that the 
passenger hangs sideways, which may cause a slight turn, which has to be corrected with the brake lines.

7. Checking the paraglider

Every  paraglider  delivered  is  checked  and  measured  several  times  by  us  before  delivery.  Nevertheless,  we 
recommend that you check the new paraglider thoroughly according to the following points. 
These instructions should also be followed if the paraglider has to be checked after intensive flight, hard manoeuvres 
or tree landings.

!

 

!

  Are all lines free of damage and correctly sewn?

The seams on the line suspension loops, on the risers and on the canopy must be checked for damage.

 

Pos.1

Pos.2

Pos.3

Pos.4

Pos.5

Summary of Contents for Airtaxi2






















Reviews: