28
KD 50 SMART G
KD50 SMART G_(220V)_IM_20190508
INSTALL ATION
• Remove the caps (2 pcs each side)
• Fix the cabinet with screws (2 pcs each side)
• Insert the caps
WARNING
- Do not remove the drawer to install it.
- Check if position is right before screw in.
VENTIL ATION
The compressor cooling system lets out heat and needs good ventilation. Therefore places with bad
ventilation are not very suitable. The Minibar must be installed in a place with an opening which guarantees
the necessary exchange of air, and it is of the utmost importance not to cover up or obstruct the grids
which provide the device with proper ventilation. One must also avoid positioning it in a place which is
directly exposed to sunlight or to other heat sources.
WARNING
You must fit the Minibar into the cabinet,
guaranteeing a cross section at the air inlet and
outlet of at least 200 cm
2
.
80 mm
200 cm
2
