IndeeLift FTS-600 User Manual
Preliminary FTS-600 UM 1-13-2022
Page
8
of
24
Copyright 2022 IndeeLift Inc. All Rights Reserved
Components and Controls:
Wired Remote
The wired remote control is connected to the FTS with a retractile cord and
used to raise and lower the seat by pressing the lever up or down. Raising or
lowering the seat takes approximately 75 seconds from the floor to a full
standing height. Seated to standing takes approximately 40 seconds. The
wired remote has graphics indicating the up and down functionality. The
wired remote is generally stored on the FTS
’s handle
s with the hanger clip.
Rise-Assist Handles
The Rise-Assist handles provide support and balance when standing from the
seat or when using the FTS in a standing mode. The Rise-Assist handles are positioned on the lower
bracket for seated operation and on the upper brackets for standing operation. If desired, one or both
rise-assist handles can be swung away from the seat by lifting one inch and then rotating them rearward
away from the seat. They swing completely out of the way to enable unimpeded transfers onto and off
of the FTS. They are also removable if desired. To remove a rise-assist handle, remove the locking pin at
the bottom of the handle, (as shown), then lift the handle upward.
Note: There are two locking pins on
the lower bracket, (one for each handle) secured to the main column with a lanyard, as shown.
The FTS Identification label is located on the back side of the FTS
column and includes the model number, serial number and patent numbers. The
IndeeLift HFL and FTS products are covered by one or more patents, including U.S.
Patent Nos. 9,808,388 B2 & 10,835,434
Handles Shown in Lower and Upper Brackets Remove Locking Pin Then Lift Handle
Upward
