7
Align base mount
assembly parallel to
miter slot
Take the base mount assembly to the
table saw and as you lower the base
mount onto the rails, position the (4)
clamping knob assemblies directly
under the slots in the base clamps.
Slide the base assembly along the rails
to position the nearest support bar at
20" from the miter slot,
Fig.11. Take a
measurement at both ends of the bar.
Loosen the phillips head screws that
hold the base clamps as necessary to
align the bar parallel to the miter slot.
Tighten the four base clamping knobs,
then tighten all eight screws that
secure the base clamps to the base
support bars.
Set final base assem-
bly position
Loosen the (4) base clamping knobs
and slide the base assembly to locate
the near side support bar at 30” from
the saw blade. See
Fig. 12. Tighten
the clamping knobs in place. Using a
3
⁄
16
" hex tool, tighten the (4) set
screws through the holes located in the
base clamps. Slide the (2) stop posi-
tioners up against the base clamps as
shown and tighten the hex bolts.
Should you ever need to remove the
base assembly from your table saw,
these stop positioners will allow you to
return to the original setup in seconds.
3
4
FIG. 11
Align base mount assembly
parallel to miter slot
Second: Slide base
assembly to align base
support bar 20" from and
parallel to miter slot
First: Lower base assembly onto
rails and base clamping knobs
Loosen base clamp
screws as necessary
Base clamps
Base sup-
port bar
20"
Third: Tighten base clamping knobs and all
eight screws that secure the base clamps
to the base support bars
FIG. 12
Set final base
assembly position
Third: Slide stop posi-
tioners up to both base
clamps and tighten hex
bolts
Base clamp
30"
First: Slide base assembly to
30" from saw blade and tight-
en all (4) clamping knobs
Base clamping knob
3
⁄
16
" hex tool
Second: Tighten (4) set screws
through holes in base clamps
Stop posi-
tioner
Miter slot
