Copyright © 2018 InCoax Networks AB. All rights reserved.
23
Confidential under NDA
Figure 24
— The VLAN Multicast Group configuration page.
Table 10
— Description of the Add Multicast Group parameters.
Term
Value
[Default Setting]
Definition
S-VLAN 10 / C-VLAN 100
Filter mode
Including/Excluding
Including/Excluding
[Excluding]
If Including, the configured Multicast Groups for this VLAN will
only allow multicast traffic for the configured multicast groups.
If Excluding, the configured Multicast Groups for this VLAN will be
blocked and all other multicast traffic will be allowed on this
VLAN.
IGMP report timeout
Set IGMP report timeout in correspondence to the IGMP query
interval.
Multicast groups
IP address
Multicast group IP
Multicast IP address from the list of Multicast Groups existing in
section
3.4.2
.
Add Multicast group
Click to add the new Multicast Group.
Update VLAN
Click to update the VLAN.
Reset
Click to discard the settings.
3.4.5
Service & QoS
Every
Modem
can have up to four queues for unicast traffic. The
Controller
has a bit rate up to 2.5 Gbps per
coaxial port (500 Mbps per 100 MHz channel). The sum of the guaranteed bit rate for all queues and all
Modems
on one channel cannot exceed the link’s bit rate. One
Modem
can have a higher guaranteed bit rate in
one or more queues than other
Modems
on the same link. The peak and guaranteed bit rate for each queue
can be configured both upstream and downstream.
If a VLAN-tagged frame, with the P-bits set, is received on the WAN-side in the
Controller
and the VLAN ID is
mapped against one or more
Modems
, the frame will be mapped against one of the queues depending on the
P-bits. Read about Type of Service (ToS) and DHCP in
section
3.4.6
.
In the main menu, hover over
MANAGEMENT
and click on
SERVICE & QoS
.
Figure 25
and
Figure 26
shows the displayed information. (The Q1 and Q2 have the same parameters as Q0
and Q3.) More details about the settings for the Service and QoS are found in
Table 11
. Click on the button
Apply
to save the settings or click on
Reset
to discard the settings.
