Copyright © 2018 InCoax Networks AB. All rights reserved.
19
Confidential under NDA
3.4.2.1
Add Multicast
Click on the
ADD MC GROUP
to add a new multicast group.
1.
Configure the relevant parameters Multicast group IP, Name, Source VLAN, and Reserved bandwidth, as
seen in
Figure 17
and
Table 6
.
2.
Click on
Add multicast group
to save the settings and add the new Multicast Group.
Figure 17
— Add Multicast.
Table 6
— Description of the Multicast parameters.
Term
Value
Definition
Multicast group IP
Multicast IP address.
Name
User defined name.
Source VLAN
1 - 4095
Enter the Source VLAN for the multicast group, if multicast VLAN
registration is used. See also Multicast VLAN in
section
3.4.4
.
Reserved
bandwidth
The reserved bandwidth on the link for this group. The reserved
bandwidth for the multicast group is deducted from the unicast capacity
of each
Modem
, i.e. each
Modem
that gets the distributed multicast
traffic.
Add multicast
group
Click to add the new multicast group.
Reset
Click to discard the settings.
3.4.2.2
Edit a Multicast Group
To edit one of the Multicast groups you can click on the IP address and you will be redirected to a page similar
to the one in
Figure 18
. Here you can edit all of the parameters found in
Table 6
except the IP address. Click on
the button
Apply
to save the settings.
Figure 18
– Edit Multicast Group.
3.4.3
Port Settings
The
Controller
has four coaxial ports and one SFP/SFP+ Trunk port for a connection to an Ethernet aggregation
network, as shown in
Figure 5
. The SFP/SFP+ Trunk port can support 1 Gbps and 10 Gbps speeds and must be
configured manually to either 1 Gbps or 10 Gbps. All coaxial links are by default activated on the band A - D at
1150 MHz by default. See
Table
7
and
Table 8
for more details.
1.
In the main menu, hover over
MANAGEMENT
and click on
PORTS
.
Figure 19
shows the corresponding web
page.
2.
Click on one of the
Settings
to change the settings for the specific port. See
Figure 20
and
Table 7
for more
details about the Trunk port and
Figure 21
and
Table 8
for more details about the coax ports.
3.
Click on the button
Apply
to save the settings.
