Enter Setup
Exit and Save
41
Recognition Only for Barcodes with
Additional Code
(*)Recognition Not Only for Barcodes
with Additional Code
Separation Character
You may decide whether to add a separation character "-" between the main
code and additional code. This function is applicable to the barcodes with
additional code, e.g., ISBN code, and ISSN code.
Add Separation Character
(*) Do not Add Separation Character
Caps Lock Control
When using the BCST-43 on a Windows system, the content of a barcode may
change with the status of the caps lock key. To avoid errors caused by such
change, you may enable the "Rid Barcode of Caps Lock Control".
(*) Caps Lock Control Barcode
Rid Barcode of Caps Lock Control
Read Code with Specific Initial Characters Only
Under this mode you may set 1-6 digits as initial characters, and the scanner will
only recognize the barcodes with these initial characters. Please refer to the
Appendix I for the supported characters.
Steps to enable reading barcodes with initial characters "A" and "6" are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set the Special Initial Character" barcode.
Summary of Contents for BCST-43
