USER MANUAL
PAGE 14
OPERATING YOUR COOKER
OPERATING BURNERS SUPPLIED FROM AN LPG CYLINDER
Before lighting the first burner, open the valve on the LPG cylinder. Then light the burner using one of the methods
described above.
When closing the flow of gas before turning off the last burner:
► Close the valve on the LPG cylinder.
► When the flame has gone out, close the tap of that burner. When the cooker is not used, the valve of the LPG cylinder
should be closed.
Adaptation to different types of gas
► The appliance is pre-set for natural gas at a pressure of 1.0 kPa.
► In case of operation with other types of gas, the burner nozzles must be changed and the minimum flame adjusted on
the gas taps.
► Replacing nozzles
1. Remove the pan stands, burner caps and flame-spreader crowns to access the burner casings.
2. Replace the nozzles using a 7 mm socket wrench according to the gas to use (see “Burner and nozzle characteristics
table”).
Loose the injector take the injector out place the proper one (as seen below).
3. Replace the burners in the correct position. Adjusting the
minimum setting for natural or city gas
4. Light the burner and turn it to the minimum position.
Extract the gas tap knob and turn the adjustment screw
next to the tap rod (depending on the model) until the
correct minimum flame is achieved.
5. Refit the knob and verify that the burner flame is stable.
6. Turn the knob rapidly from the maximum to the
minimum setting: the flame should not go out. Repeat the
operation on all gas taps.
