13
Pole Mounting
1. Remove the 4 nuts and 4 screws from the mounting kit.
2. With the enclosure open, drop 1 nut into each drilled corner of the box.
3. Use a screwdriver to push the nut down and set it in place.
Figure 3.5 Placing the nut in the enclosure
4. Place the 2 brackets on the back of the enclosure so that the flanges on the brackets will point toward the ground.
5. Attach the mounting brackets to the enclosure using 2 screws for each bracket. Make sure that the screws
properly thread into the nuts that you seated in steps 2 and 3.
6. Place 2 hose clamps over the mounting pole and tighten them until they are almost secure.
7. Place the flanges from the mounting bracket into each of the hose clamps.
8. Completely tighten the hose clamps until the entire controller unit is secure on the pole.
